Lane Departure Alert; Rear Cross Traffic Alert; Traffic - Toyota RAV4 2014 Quick Reference Manual

FEATURES/OPERATIONS
Blind Spot Monitor (BSM) with Rear
Cross Traffic Alert (RCTA) (if equipped)
System ON/OFF
Indicator
Blind Spot Monitor (BSM) uses an indicator light in the outside mirror to alert the
driver to a vehicle in the blind spot.
When backing up the vehicle, Rear Cross Traffic Alert (RCTA) uses an indicator
light in the outside mirror and an audible sound to alert the driver if another
vehicle is approaching from the left or right.
Refer to the Owner's Manual for more details on this system before attempting
to use it.
Lane Departure Alert (LDA)
The Lane Departure Alert recognizes the visible lane markers using a camera as a
sensor and alerts the driver with beeping and flashing indicators when the vehicle
deviates from its lane.
Indicator
Buzzer
26
SAFETY AND EMERGENCY FEATURES
Seat belts
If belt is fully extended, then retracted even slightly, it cannot be re-extended
beyond that point, unless fully retracted again. This feature is used to help hold
child restraint systems securely.
To find more information about seat belts, and how to install a child restraint
system, refer to the Owner's Manual.
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or replaced, turn
the engine switch to "ON" and press and hold the "
blinks three times. Let the vehicle sit for a few minutes to allow initialization to
complete.
Refer to the load label on the door jamb or the Owner's Manual for tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains
on, take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or changes
in tire pressure from natural air leakage. If the system has not been initialized
recently, setting the tire pressures to factory specifications should turn off the
light.
Take up slack
Too high
Keep as low on
hips as possible
System reset initialization
SET" button
1. Push and hold "
until the indicator blinks three times.
2. Wait a few minutes to allow
initialization to complete.
SET" button until indicator
27