Remote Sensor (Thn132N); Getting Started; Insert Batteries; Remote Sensor - Oregon Scientific EMR211 User Manual

REMOTE SENSOR (THN132N)

1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch
REFERENCE Other supported sensors include models:
THGN328N, THGR328N, BTH sensor, THN318N.

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery change.
LOCATION
Outdoor temperature area
Indoor temperature area
2
4
3 5
MEANING
Outdoor sensor batteries low
Indoor sensor batteries
low / main unit batteries low

REMOTE SENSOR

The main unit can collect data from up to 5 sensors.
To set up the sensor:
1. Open the battery compartment.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m); and can shield it from direct
sunlight or wet conditions for an accurate reading.
1.5 m (5 ft)
3