Bluetooth Detail Setting - Kenwood KDC-X896 Quick Start Manual

Function of KDC-X896, KDC-BT852HD
Bluetooth setup

Bluetooth detail setting

You can configure the initial settings of this unit.
1
Enter the Bluetooth mode
Press the [ ] button.
"BT MODE" is displayed.
2
Enter the Function setting mode
Press and hold the Control knob.
3
Select the Detailed Settings item
Select the following items using the Control
knob.
"Settings" "Detailed Settings"
4
Select a desired Bluetooth detail setting item
Turn the Control knob to select a Bluetooth
detail setting item, and then press the Control
knob.
Display Description
"Detailed Settings"
"Auto Answer" Automatically answers a call after lapse of the
preset time interval.
"OFF": Does not answer the phone call
automatically.
"0SEC": Automatically answers the phone
call at once.
"1SEC" – "8SEC" – "99SEC":
Automatically answers the phone call after
lapse of 1 – 99 seconds.
"Auto Reconnect" When set to "ON", starts re-pairing with the
registered Bluetooth device automatically
when it becomes unpaired.
"ON" / "OFF"
"Bluetooth HF/
Specifies the output speakers for hands-free
Audio" voice communication and Bluetooth audio
sound.
"Front" : Outputs sound from the front
speakers.
"All" : Outputs sound from the front and rear
speakers.
"Call Beep" Sets whether to output a beep from the
speaker when a call comes in.
"ON" : Outputs a beep.
"OFF" : Does not output a beep.
"MIC Gain" Adjusts the sensitivity of the microphone for
telephone call or adjusts the voice of the caller.
"1" – "20" – "30"
"NR Level" Reduces the noise generated by the
surrounding environment without changing
the microphone volume or adjusts the voice
of the caller when it is not clear. Setting to
a positive (+) value enhances the noise
reduction effect.
"-1" – "0" – "+1"
54
|
KDC-X896/ KDC-BT852HD/ KDC-X496/ KDC-452U/ KMR-550U
"Echo Cancel Level" Sets the echo cancellation level.
"-1" – "0" – "+1"
( : Factory setting)
5
Select a Bluetooth detail setting value and
determine it
Turn the Control knob to select desired setting,
and then press the Control knob.
The previous item is displayed.
6
Exit the Function setting mode
Press and hold the [ ] button.
Contents
55
|
English