Getting Started; Device Overviews; Charging The Handheld Device; Charging The Collar - Garmin Pro 550 Owner's Manual

Getting Started

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Setting Up the Pro 550 System
Before you can use the Pro 550 system, you must set up the
devices.
1
Attach the dog collar device to the collar strap
Dog Collar Device to the Collar
2
Charge the handheld device
Device).
3
Charge the dog collar device
4
Turn on the devices (Turning On the Dog Collar
5 If necessary, pair the dog collar device with the handheld
device (Pairing a Dog Collar Device with the Handheld
Device).

Device Overviews

Pro 550 Handheld Device
Intensity level and training mode dial
Battery level
Tone key
Dog collar device toggle switch
Mode toggle switch
Training keys
Pro 550 Dog Device
Power key
Status LED
Lights
Getting Started
WARNING
(Attaching the
Strap).
(Charging the Handheld
(Charging the Collar).
Device).
Contact points
Charging clip contacts
Attaching the Dog Collar Device to the Collar
Strap
1 With the buckle facing outward, insert the end of the collar
strap through the slot
2
Pull most of the collar strap through the two slots
dog device.
3
Insert the end of the collar strap through the slot
opposite side of the device.
4
Pull the strap until it is tight across the front of the device.

Charging the Handheld Device

You should fully charge the battery before you use the device
for the first time or whenever the battery is low
Battery Level). It is normal for the battery to discharge in
approximately 7 to 10 weeks when the device is not in use.
Charging a fully depleted battery takes about 2 hours.
NOTE: The device will not charge when it is outside the
temperature range of 32° to 104°F (0° to 40°C).
1
Lift the weather cap .
2 Plug the small end of the power cable into the mini-USB port
on the device.
3
Plug the other end of the power cable into an appropriate
power source.
The status LED is solid red when the device is charging.
4
After the status LED turns solid green, unplug the power
cable from the device.

Charging the Collar

To prevent corrosion, thoroughly dry the contacts on the collar
and the surrounding area before connecting the charging clip.
You should fully charge the battery before you use the device
for the first time or whenever the battery is low
on the collar device.
(Checking the
NOTICE
(Checking the
on the
on the
1