Engine Coolant Check; Brake Fluid Check; Washer Fluid Check; Changing The 12V Battery - Ford Kuga Owner's Manual

ENGINE COOLANT CHECK

WARNING
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your physician.
Note: Make sure that the level is between
the MIN and the MAX marks.
Note: Coolant expands when it is hot. The
level may therefore extend beyond the MAX
mark.
If the level is at the MIN mark, add coolant
immediately.
Adding Engine Coolant
WARNINGS
Only add coolant when the engine is
cold. If the engine is hot, wait 10
minutes for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Do not remove the filler cap when
the engine is hot. Wait for the engine
to cool down.
Undiluted coolant is flammable and
may ignite if spilt on a hot exhaust.
Note: In an emergency, you can add just
water to the cooling system to reach a
vehicle service station. Have the system
checked by an authorized dealer as soon as
possible.
Note: Prolonged use of incorrect dilution
of the coolant can cause engine damage
from corrosion, overheating or freezing.
Note: Do not add coolant further than the
MAX mark.
1. Remove the filler cap. Any pressure will
escape slowly as you unscrew the cap.
Kuga (CBS) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, CG3585en enGBR, Edition date: 02/2014, None
Maintenance
2. Add a 50/50 mixture of coolant and
water using fluid that meets the Ford
specifications. See Technical
Specifications (page 198).
3. Replace the filler cap. Turn it until you
feel a strong resistance.

BRAKE FLUID CHECK

Fluid levels between the MIN and MAX
lines are within the normal operating range;
there is no need to add fluid. If the fluid
levels are outside of the normal operating
range, the performance of the system
could be compromised; seek service from
your authorized dealer immediately.

WASHER FLUID CHECK

Note: The reservoir supplies the front and
rear washer systems.
When adding fluid, use a mixture of washer
fluid and water to help prevent freezing in
cold weather and improve the cleaning
capability. We recommend that you use
only high quality washer fluid.
For information on fluid dilution, refer to
the product instructions.

CHANGING THE 12V BATTERY

For vehicles with Start-Stop the
battery requirement is different. You
must replace the battery with one of
exactly the same specification.
The battery is located in the engine
compartment. See Maintenance (page
184).
Note: You must reset the bounce-back
feature for the power windows. See Power
Windows (page 57).
189
WARNING