Maintaining A Waterproof Seal - Sealife DIGITAL PRO FLASH Instruction Manual

VII. Maintaining a waterproof seal
The flash uses an o-ring to maintain a waterproof seal and a
gasket to prevent sand and debris from reaching the o-ring.
Removing the O-ring and Gasket
1. Grab white cable adapter and pull up to unplug the cable from
the flash. Do NOT pull on the wire.
2. Remove gasket with your fingers.
3. Remove O-ring with your fingers
Important: Do NOT use tools or sharp objects or you may
damage the O-ring or Gasket.
28
Every flash is depth tested to ensure a
waterproof seal. It is your responsibility to
regularly inspect the o-ring and sealing
surfaces and maintain this waterproof seal.
Always perform these inspection procedures
before using underwater.