Hotpoint 5TCG Instructions Manual page 16

Care and Cleaning
COOKER FINISH
Vitreous Enamel
Hotplate, burner caps, grill
pan, oven base and rear,
inside of grill compartment,
inside of doors, control panel.
Paint
Plinth, fascia bottom trim,
side panels, lid trim,
rear end caps
Aluminium
Hotplate burner bodies
Chromium Plating
Oven shelves, grill pan grid,
grill pan handle support
Plastic
Grill pan handle, door
handles, control knobs
Glass
Lid, door fronts
NOTE: To ensure rapid lighting of the hotplate burners every time they are used, the
electrodes must be kept clean and dry. Remove any food spillage or cleaning materials from
the electrode using a small nylon brush such as a tooth brush.
REPLACEMENT OF OVEN LIGHT BULB (model 5TCG only):
CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE
REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC
SHOCK
Light bulbs are not covered by the manufacturer's guarantee.
A new 15W, 300˚C rated SES bulb can be obtained from your cooker supplier or any
major electrical retailer.
1. Remove the shelves from the oven.
2. Unscrew the lens using a thick cloth to protect your fingers in the unlikely
event of a lens fracture.
3. Unscrew bulb.
4. Fit new bulb and refit lens.
14
CLEANING METHOD
Cloth wrung out in warm soapy water. Stubborn
stains can be removed with a cream paste,
liquid cleaner or by rubbing with fine steel wool
soap pads.
Check that the cleaning agent is approved by the
Vitreous Enamel Development Council.
Wash with a cloth wrung out in warm soapy water
only.
DO NOT USE ABRASIVES.
Similar to paint cleaning above. Use a nylon brush to
remove any cleaning materials, water or dirt from the
hotplate burners.
Wipe with a cloth wrung out in warm soapy water.
A fine steel wool soap pad or a chrome or stainless
steel cleaner may be used.
Wipe with a cloth wrung out in warm soapy water.
Stubborn stains can be removed with a cream
cleaner.
Wash with cloth wrung out in warm soapy water
only. Do not use ABRASIVES. Polish with a dry cloth
or kitchen towel.