Table of Contents
Advertisement
17.
Serial port connector (10-1 pin COM)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
Z97-WS
Z97-WS Serial port (COM1) connector
The COM module is purchased separately.
18.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
Z97-WS
Z97-WS Chassis intrusion connector
Z97-WS
COM1
PIN 1
CHASSIS
PIN 1
1-37
Hide quick links:
Advertisement
Table of Contents
