Connectors And Buttons - Axis P1224–E User Manual

AXIS P1224–E Network Camera
Hardware Overview
NOTICE TICE
NO NO TICE
Make sure that the wires stay in the correct order and that the cable shield makes good contact with the connector shield.
6. Use a crimping tool to fasten the connector to the cable.

Connectors and Buttons

For technical specifications, see page 48.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP) or an optical fiber cable. All cables connecting the
product to the network shall be intended for their specific use. Make sure that the network devices are installed in
accordance with the manufacturer's instructions. For information about regulatory requirements, see Electromagnetic
Compatibility (EMC) on page 2 .
RJ12 Connector
The R12 connector is used for connecting the sensor unit to the main unit. For information on how to shorten the sensor unit
cable see Shorten Sensor Unit Cable on page 5 .
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, time lapse recording
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for example:
PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes
active (shown under System Options > Ports & Devices).
Power Connector
2-pin terminal block for power input. Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either a rated
output power limited to ≤100 W or a rated output current limited to ≤5 A.
14 mm 14 mm
1
6