Dial Cycles; Start Delay - Hotpoint HDA105 Owner's Manual

About the dial cycles.
OFF
ON
PLATE
WARMER
(HEATED DRY ON)
(HEATED DRY OFF)
RINSE & HOLD
START

START DELAY

2
(HOURS)
4
6
OFF
PLATE
WARMER
(HEATED DRY ON)
RINSE & HOLD
OFF
ON
PLATE
WARMER
(HEATED DRY ON)
RINSE & HOLD
10
Rinse & Hold
HDA900 and HDA930 only)
WATER
SAVER
For rinsing partial loads that will be washed later. Do not
use detergent.
Make sure HEATED DRY OFF is selected.
1
Be sure the door is unlatched.
2
Slowly turn the Dial to RINSE & HOLD.
3
Latch the door to start the cycle.
4
Start Delay
The START DELAY will allow you to delay the start
time of any cycle not on the Dial automatically for up
to 6 hours.
Be sure the door is unlatched.
1
Select the wash cycle and Option you want.
(HEATED DRY OFF) 2
Slowly turn the Dial to desired time. The CYCLE ON
3
light will come on.
Latch the door to start the cycle.
4
Plate Warmer
HDA930 only)
WATER
SAVER
For warming clean dishes and serving plates. This cycle
will take approximately 32 minutes.
Load clean dishware to be warmed.
1
(HEATED DRY OFF)
Select HEATED DRY ON.
2
Be sure the door is unlatched.
3
Slowly turn the Dial to PLATE WARMER.
4
Latch the door to start the cycle.
5
(HDA150, HDA180, HDA200, HDA300, HDA330,
(HDA900 and HDA930 only)
(HDA200, HDA300, HDA330, HDA900 and