User Interface - Tekmar tekmarNet2 Thermostat 530 Quick Setup Manual

7.

User Interface

Auto, Heat, Cool, Off
8.
Critical Settings
The following settings are essential to the successful operation of the system.
Important Note: Set switch setting #4 and tekmarNet
setting once installation has been completed.
Press
• Press and hold down both the
• Release both buttons once the step has been reached.
• Press the
+
• Press and hold down both the
Together
• After 10 seconds of no button activity, the display goes back to normal operation.
Display
For a full list of settings and operational details, please refer to the thermostat Installation and Operation Manual
(D530) included with compatible tekmarNet
tekmar Control Systems Ltd., Canada, tekmar Control Systems, Inc., U.S.A. Head Offi ce: 5100 Silver Star Road,
Product design, software and literature are Copyright © 2010 by:
tekmar Control Systems Ltd. and tekmar Control Systems, Inc.
Mode button
®
system control to Unlock to change Access level to Installer. Return to Lock
or the button to change the setting, if available.
Range Access
Installer
°F or °C
Default = °F
User
0, 1, 2, 3
Installer
Default = 1
Hyd
(Hydronic)
or Oth
Installer
(Other)
Default =
Hydronic
OFF, dLy
(delay), On
Installer
Default = On
® controls or download the brochure from www.tekmarcontrols.com
Vernon, B.C. Canada V1B 3K4, 250-545-7749, Fax. 250-545-0650 Web Site: www.tekmarcontrols.com
Fan button
Switch between Auto or On
and buttons for 2 seconds to change from one step to the next.
and buttons for 2 seconds to go to the next step, OR
Description
TEMPERATURE UNITS
Press the or the
°C and vice versa.
FAN MODE
Select how the fan should operate together with heating
and cooling.
0 = Manual operation only
1 = Operate fan with cooling only
2 = Operate fan with heating and cooling
3 = Operate fan with heating only
HEATING TERMINAL TYPE
Select if the heating for this zone is hydronic or non-
hydronic (other).
Available when:
• A reset control is present on the tekmarNet
system.
HEATING SUPPLY PUMP
Select how the system supply pump should operate:
On = system pump on during a call for heat.
Delay = system pump delayed 3 minutes for thermal
motor (wax actuator) zone valves to open.
Off = system pump not turned on during a call for heat.
Use when a manifold uses a Zone Group Pump.
Available when:
• A reset control is present on the tekmarNet
AND Heating terminal type is set to Hydronic.
All specifications are subject to change without notice.
2 of 2
button to change from °F to
®
®
system
Printed in Canada. Q 530 - 08/10.
Set to