Chrysler Town & Country 2014 Owner's Manual page 268

266 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
1. Cycle the ignition to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
away from the HomeLink® button you wish to pro-
gram while keeping the HomeLink® indicator light in
view.
3. Simultaneously press and hold both the HomeLink®
button you want to program and the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indi-
cator light. The HomeLink® indicator will flash slowly
and then rapidly after HomeLink® has received the
frequency signal from the hand-held transmitter. Re-
lease both buttons after the indicator light changes
from slow to rapid.
5. At the garage door opener motor (in the garage),
locate the "LEARN" or "TRAINING" button. This can
usually be found where the hanging antenna wire is
attached to the garage door opener/device motor.