Laser Operation; Important Safety Instructions For Batteries; Installing And Removing Battery; Specifications - DeWalt DW030 Instruction Manual

SPECIFICATIONS

Laser Power < 1 mw, CLASS 2 LASER
PRODUCT
Range [at 70°F (22°C)] 1'–100' (300 mm–30 m)
Accuracy [at 70°F (22°C)] ± 1/8" (3 mm)
Power Source two AAA (LR03) size batteries
Battery Voltage 2 x 1.5 V
Storage Temperature 20°F to 160°F (–7°C to 70°C)
INTENDED OPERATING CONDITIONS
Environmental Indoor and Outdoor
Water resistant
Temperature 20°F to 120°F (–7°C to 50°C)
Relative Humidity ≤ 85%
Air Quality Pollution Degree 3
Altitude ≤ 11,500' (3,500 m)

LASER OPERATION

• To extend battery life per charge, turn the laser off when it is not
in use.
• To ensure the accuracy of your work, check the laser
calibration often. Refer to Field Calibration Check under
Laser Maintenance.
• Before attempting to use the laser, make sure the device does
not show any defects and is in proper working order.
• Extreme temperature changes can cause movement or shifting
of building structures, metal tripods, equipment, etc., which can
effect accuracy. Check your accuracy often while working.
• If the device is dropped or has suffers a sharp blow, have the unit
checked by a qualified service center before using the laser.
Important Safety Instructions
for Batteries
injury or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the battery label
• Always insert batteries correctly with regard to polarity (+ and –),
DC
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new batteries. Replace all of them at the
• Remove dead batteries immediately and dispose of per local
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several
Installing and Removing Battery (Fig. 2)
NOTE: This Laser Distance Measurer (LDM) is powered by two
AAA (LR03) size 1.5
INSTALLING THE BATTERY PACK
3
WARNING: Batteries can explode, or leak, and can cause
and package.
marked on the battery and the equipment.
same time with new batteries of the same brand and type.
codes.
months.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
V batteries.
DC
1. Lift up the battery compartment cover (A) as shown
in Figure 2.