Wiring & Setting Up - Tannoy OCV 6 Owner's Manual

WIRInG AnD settInG UP:
1. Remove the euroblock connector from the socket
2. Feed the cable through the rubber grommet then
connect the euroblock connector to the cable observing
the correct polarity
3. For connection to an amplifier, use pins 1 and 2:
Pin 1 is positive
Pin 2 is negative
For connection to additional speakers in a distributed line,
pins 3 and 4 are in parallel where:
Pin 3 is negative
Pin 4 is positive
4. Connect the euroblock connecter then replace the rubber grommet
to ensure the speaker is sealed.
THE sPEAKER Is sUPPLIED IN LOW IMPEDANCE MODE.
NEVER CONNECT THE sPEAKER TO A 70/100 VOLT AMPLIFIER
WHILE IT Is sET FOR LOW IMPEDANCE.
5. The OCV 6 and OCV 8 is fitted with a 60W transformer. When used in
distributed-line systems, the transformer can be tapped at
60W, 30W, and 15W, with an additional 7.5W tapping for
70.7V line systems.
06_ OCV OWNER MANUAL