Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Tannoy OCV 6
Summary of Contents for Tannoy OCV 6
- Page 1 Series O W N E R ’ s M A N U A L OCV OWNER MANUAL_01...
-
Page 2: Table Of Contents
A secondary support line should be attached from the safety loop on the rear of the product to a source point on the ceiling. Please consult the relevant construction codes in your region. Tannoy will not be held responsible for any damages caused by the improper installation of these loudspeakers. sAFETY NOTE: In order to comply with the relevant fire safety regulations (ie. -
Page 3: Product Feature Identification
PRoDUct FeAtURe IDentIFIcAtIon ocV 6 / ocV 8 HAnGInG / sAFetY PoInt eURoBLocK tAP seLectoR OCV OWNER MANUAL_03... -
Page 4: Accessories
AccessoRIes GRIPPLe sPeeD cLAMP HAnGInG / sAFetY WIRes WeAtHeR Boot 3/8” scReWeD RoD ADAPtoR 04_ OCV OWNER MANUAL... -
Page 5: Installation Guide
InstALLAtIon GUIDLInes 1. Gripple Instructions 2. Thread hanging cable 3. secure the cable to the through Gripple as shown fixing as shown. NOTE: Repeat 1 and 2 for the safety cable. 5. The hanging cable 4. Pull the cable through to adjust height. Pull to tighten. should be attached to Insert release key to loosen or adjust. -
Page 6: Wiring & Setting Up
NEVER CONNECT THE sPEAKER TO A 70/100 VOLT AMPLIFIER WHILE IT Is sET FOR LOW IMPEDANCE. 5. The OCV 6 and OCV 8 is fitted with a 60W transformer. When used in distributed-line systems, the transformer can be tapped at 60W, 30W, and 15W, with an additional 7.5W tapping for... -
Page 7: Dimensions
DIMensIons ocV 6 399.5 399.5 (15.73”) 423.2 [15.73"] 423.2 [16.66"] (16.66”) 382.1 382.1 (15.04”) [15.04"] O260.0 Ø260.0mm (10.23”) [10.23"] Pendant 601 ocV 8 492.6 492.6 465.7 (19.39”) 445.5 445.5 465.7 [19.39"] (18.33”) (17.54”) [17.54"] [18.33"] O302.0 302.0 (11.89”) [11.89"] Pendant 801... -
Page 8: Technical Specifications
A full range of measurements, performance data, and Ease™ Data can be downloaded from www.tannoy.com Tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing methods will always equal or exceed the published specifications, which Tannoy reserves the right to alter without prior notice. Please verify the latest specifications when dealing with critical applications. -
Page 9: Warranty
PLeAse note: In order to direct you to the appropriate service facility a return authorization and instructions must be issued in advance - do not send any equipment to any Tannoy or TC Group Americas facility without prior authorization or it will be refused. In some cases a local service facility can be recommended. -
Page 10: Declaration Of Conformity
DecLARAtIon oF conFoRMItY The following apparatus is manufactured in China for Tannoy Ltd of Rosehall Industrial Estate, Coatbridge, scotland, ML5 4TF and conform(s) to the protection requirements of the European Electromagnetic Compatibility Standards and Directives relevant to Domestic Electrical Equipment. The apparatus is designed and constructed such that... - Page 11 notes OCV OWNER MANUAL_011...
- Page 12 TCGA (Americas sales) T: 00 1 (519) 745 1158 E: info@tcgroup-americas.com Tannoy Middle East T: 00 971 (04) 4401208 E: enquiries@tannoy.com Tannoy adopts a policy of continuous improvement and product specification is subject to change. tannoy.com 012_ OCV OWNER MANUAL...