Philips 32PFL6606H User Manual page 35

Access DVB-S channels (for certain models
only)
If your satellite is connected to the SAT
connector, you can receive satellite channels.
Press > [Watch satellite] to watch
satellite channels.
Install analogue channels
You can search and store analogue TV
channels manually.
Step 1: Select your system
Note: Skip this step if your system settings
are correct.
1. While you watch TV, press
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Analogue: Manual installation] >
[System], then press OK.
4. Select the system for your country or
region, then press OK.
Step 2: Search and store new TV channels
1. In the [Analogue: Manual installation]
menu, select [Find channel], then press OK.
2. Select one of the following options:

Press the Navigation buttons or
Numeric buttons to manually enter the
channel frequency.

Select [Search] then press OK to
search for the next channel
automatically.
3. When the correct channel frequency is
entered, select [Done], then press OK.
4. Select [Store as new channel], then press
OK to store the new TV channel.
Install digital and satellite channels
Install digital channels
To improve TV reception, reposition the
antenna. You need to know the correct
frequency to tune. For best results, contact
the service provider or get a professional
installer.
1. Press
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Digital: Reception test] >
[Search], then press OK.
4. Press the Numeric buttons to enter the
.
channel frequency.
5. Select [Search], then press OK.
6. When the correct channel is located,
select [Store], then press OK.
7. Press
Notes


Install satellite channels
Available on certain models only.
If your satellite is connected to the SAT
connector, you can receive satellite channels.
1. While you watch TV, press
2. Select [Setup] > [Search for satellite] >
[Reinstall channels].
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select [Finish], and then
press OK.
Fine-tune channels
If the reception of an analogue TV channel is
poor, fine-tune the TV channel.
1. Press
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Analogue: Manual installation] >
[Fine tune], and then press OK.
4. Press
.
to exit.
If the reception is poor, reposition your
antenna and repeat the procedure.
If you receive the channel with DVB-C,
select [Automatic] in [Symbol rate
mode] unless your cable provider
supplies you with a specific symbol rate
value.
.
or to fine-tune the channel.
.
EN 35