TOTALINE P374-1900 Owner's Manual page 61

Programming the Thermostat to Programming the Thermostat to
Operate a Dual Fuel System Operate a Dual Fuel System
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
If the HP/GAS Jumper is not set for HP, then steps 21
and 22 will be unavailable (see Install Manual pg. 5.4).
On
Select Dual Fuel
operation*, (On), or
normal operation*, (Off).
Off
13
Adjust the Changeover
Balance Point for the
outside sensor** (RS2).
( 32 - 85 F, OF=no sensor)
( 0 - 30 C)
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
*
To see the outputs that will be energized in Dual Fuel or Normal
operation, please see the next page.
**
In the case of Dual Fuel operation (Dual Fuel set to 'ON'),
an outside sensor is required.
TOTALINE
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
2 i
Setup
OFF
22
35
Setup
Outside
Page 13.2
MODE
MODE
Press
MODE
Press
PROGRAM