Configuring A Thermostat Output Jumper For Dehumidification Operation - TOTALINE P374-1900 Owner's Manual

Configuring a Thermostat Output Jumper Configuring a Thermostat Output Jumper
for Dehumidification Operation for Dehumidification Operation
To control a MISC output for dehumidification, place the MISC1,
MISC2, or MISC3 jumper on the terminal labeled DEHUM (see
diagram below). This will supply 24VAC to the selected MISC
terminal based on the dehumidification programming in the following
pages. Only one of the three outputs (MISC1, MISC2, or MISC3) is
required to have a jumper. For more information regarding the MISC1,
MISC2, and MISC3 outputs, please see section 21.
In the diagram below, the MISC2 jumper has
been set for DEHUM operation.
ELEC
GAS
W3
PROG HP
HUM GAS
DEHUM
Y2
B
(MISC1
MISC3 MISC2 MISC1 O
ONLY)
W1
W2
Y1
MISC1
G
RS2
MISC2
MISC3
CK1
RS+5
CKGND
Rs1
R
INSTALL HUMIDITY
MODULE WITH SENSING
RSGND
ELEMENT OUTWARD
C
MISC3 MISC3
OK
W3
PROG
HUM
DEHUM
MISC3 MISC2
IMPORTANT CAUTION
NEVER PUT MORE THAN ONE JUMPER
ON THE SAME MISC JUMPER BLOCK!
THIS MAY DAMAGE THE THERMOSTAT
AND VOID YOUR WARRANTY
Page 10.2
TOTALINE
10
Y2
(MISC1
MISC1
ONLY)