Universal Garage Door Opener (Homelink ® ); Programming Homelink - Jeep Liberty 2010 User Manual

UNIVERSAL GARAGE DOOR OPENER (HomeLink
• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN
position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink
transmitter button until the HomeLink
rapidly blinking light, then release both the HomeLink
buttons. This may take up to 30 seconds, or longer in rare cases.
• Press and hold the just-programmed HomeLink
constantly, programming is complete and the garage door should open.
• Your motorized door or gate will open and close while you are programming the
universal transceiver. Do not program the transceiver if people or pets are in the
path of the door or gate.
• Do not run your vehicle in a closed garage or confined area while programming
the transceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO)
which is odorless and colorless. Carbon Monoxide is poisonous when inhaled and
can cause you and others to be severely injured or killed.
NOTE:
• Only use this transceiver with a garage door opener that has a "stop and reverse" feature
as required by Federal safety standards. This includes most garage door opener models
manufactured after 1982. Do not use a garage door opener without these safety features.
Call toll-free 1–800–355–3515 or, on the Internet, at www.HomeLink.com for safety
information or assistance.
• If you are having difficulty programming your HomeLink
was manufactured after 1995, you may have a rolling code. Follow the steps below for
Programming A Rolling Code System.
ELECTRONICS

Programming HomeLink

Begin Programming
• The HomeLink
overhead console.
• Erase all channels before you begin
programming by holding the two outside
buttons for up to 20 seconds until the red
indicator flashes.
®
indicator flash rate changes from a slow to a
®
and the hand-held transmitter
®
button; if the indicator light stays on
WARNING!
®
33
®
)
®
®
buttons are located in the
®
buttons while
®
button and the hand-held
and your garage door opener