Jump-Starting Procedure - Jeep Liberty 2010 User Manual

WHAT TO DO IN EMERGENCIES
Preparations for Jump-Start
• The battery in your vehicle is located in the front of the engine compartment, behind the
left headlight assembly.
NOTE: The positive battery post is covered with a protective cap. Lift up on the cap to gain
access to the positive battery post.
• Take care to avoid the radiator cooling fan whenever the hood is raised. It can start
anytime the ignition switch is on. You can be injured by moving fan blades.
• Remove any metal jewelry, such as watch bands or bracelets, that might make an
inadvertent electrical contact. You could be severely injured.
• Batteries contain sulfuric acid that can burn your skin or eyes and generate
hydrogen gas which is flammable and explosive. Keep open flames or sparks
away from the battery.
• Set the parking brake, shift the automatic transmission into PARK and turn the ignition to
LOCK.
• Turn off the heater, radio, and all unnecessary electrical accessories.
• If using another vehicle to jump-start the battery, park the vehicle within the jumper
cables reach, set the parking brake and make sure the ignition is OFF.
Do not allow vehicles to touch each other as this could establish a ground
connection and personal injury could result.

Jump-Starting Procedure

Failure to follow this procedure could result in personal injury or property damage
due to battery explosion.
Failure to follow these procedures could result in damage to the charging system of
the booster vehicle or the discharged vehicle.
• Connect the positive (+) end of the jumper cable to the positive (+) post of the discharged
vehicle.
• Connect the opposite end of the positive (+) jumper cable to the positive (+) post of the
booster battery.
WARNING!
WARNING!
WARNING!
CAUTION!
54