Related Manuals for Autotek Stealth 600.S
Summary of Contents for Autotek Stealth 600.S
- Page 1 4Channel Musical High Performance Flush-Mount Amplifier MODEL: 600.S Owner’s Manual...
-
Page 2: Dear Customer
AUTOTEK and the Electronic Industry Associations Consumer Electronic Group want you to get the most out of your equipment by playing it at a safe level, a level that lets the sound come through loud and clear without annoying blaring distortion;... -
Page 3: Installation
Introduction Your Autotek STEALTH amplifier has been designed to give you very high performance, and valuable features, at a reasonable price. Take time to read over this brief set of instructions, and you will get full enjoyment from your system. -
Page 4: Power Supply Connections
Power Supply Connections The +12VDC and ground wires should be heavy gauge standard copper wires with heavy insulation. The wire gauge should be 4AWG for the AMX50.2 and AMX100.2 or larger. In addition, it has a 12V remote control wire and it should be 14AWG-18AWG. It is preferable to have longer speaker wires and shorter power supply wires to minimize power losses. - Page 5 Caution First make +12V wire connection then the ground connection and finally the remote connection. Furthermore the +12V wire must always be fused at the battery for production against possible damage. If you need to replace the power fuse, replace it with a fuse of the same value. Using a fuse of a different type or rating m result in a serious hazard.
- Page 8 • The amplifier can be used in the STEREO, 3CH MODE, and 2CH MONO MODE as shown in Fig. 4, Fig. 5, Fig. 6. • The speaker wires should be connected to the speaker terminal on amplifier. • Notice that most speakers have a polarity marking such as “+” or a dot on speaker terminals and these marking denote the positive terminals of the speaker and are used as a guide to phase the speakers.
- Page 9 10. Fuse It protects both the amplifier and automobile electrical system from fault conditions. Use a standard automotive fuse, 600.S:40Ax2. 11. Power connection Connects +12VDC power wire from the battery and also connects ground wire from a suitable ground point on the chassis.
-
Page 10: Specifications
SPECIFICATIONS STEALTH *Audio power output per Channel, *both channels driven at 14.4VDC. 75watts/ch - 4 ohm Stereo, 12.0volt 20Hz-20kHz <.018%THD 175w/ch - 2 ohm Stereo, 14.4volt 20Hz-20kHz <.02%THD 350watts x 2 - 4 ohm Stereo, 14.4volt 20Hz-20kHz <.05%THD * Signal to Noise Ratio >90dB * Frequency Response 10Hz-40kHz,... - Page 11 We Want You Listening for a Lifetime Used wisely, your new sound equipment will provide a lifetime of fun and enjoyment. Since hearing damage from loud noise is often undetectable until it is too late, this manufacturer and the Electronic Industries Association's Consumer Electronics Group recommend you avoid prolonged exposure to excessive noise.