Subscribe to Our Youtube Channel
Related Manuals for Autotek 300. S
Summary of Contents for Autotek 300. S
- Page 1 2Channel Musical High Performance Flush-Mount Amplifier MODEL: 300. S 400. S 500. S O w n e r ’ s M a n u a l O w n e r ’ s M a n u a l...
-
Page 2: Dear Customer
AUTOTEK and the Electronic Industry Associations Consumer Electronic Group want you to get the most out of your equipment by playing it at a safe level, a level that lets the sound come through loud and clear without annoying blaring distortion;... - Page 3 Introduction Your Autotek STEALTH amplifier has been designed to give you very high performance, and valuable features, at a reasonable price. Take the time to read over this brief set of instructions, and you will get full enjoyment from your system.
-
Page 4: Power Supply Connections
Fig. 1 Installation of amplifier Power Supply Connections The +12VDC and ground wires should be heavy gauge standard copper wire with heavy insulation. The wire gauge should be 4AWG for the 300.S, 400.S, 500.S or larger. In addition it has a 12V remote control wire and it should be 14AWG-18AWG. -
Page 5: Power Input Connection
Power Input Connection Fig. 2 Power Input Connections Caution First make +12V wire connection then the ground connection and finally the remote connection. Furthermore the +12V wire must always be fused at the battery for protection against possible damage. If you need to replace the power fuse, replace it with a fuse of the same value. -
Page 6: Signal Input Connections
SIGNAL INPUT CONNECTIONS Fig. 3 Signal Input Connections Note: RCA Cable not supplied with unit. - Page 7 DOTTED LINES SHOW 4-SPEAKER CONNECTIONS. IN THIS CASE, IT IS BETTER TO USE 4 ohm SPEAKER TO PREVENT ANY DAMAGES. Fig. 4 Speaker Output Connections—MONO Mode The amplifier can be used in the STEREO and BRIDGED mode as shown in Fig. 4, Fig. 5. The speaker wires should be connected to the speaker terminal on amplifier.
-
Page 8: Features And Controls
FEATURES AND CONTROLS Fig. 5 Features and Controls... - Page 9 RCA Line Output Jacks Full range output from channel L + R inputs is provided at Line Out Jacks RCA Low Level Input Jacks It allows left and right inputs to be connected to the amplifier using RCA plugs. Input Level Control It allows for the adjustment of the gain of both channels to match the output level of the source.
-
Page 10: Specifications
SPECIFICATIONS STEALTH 300.S 400.S 500.S *Audio power output per Channel, both channels driven at 14.4VDC. 50watts/ch 75watts/ch 150watts/ch - 4 ohm Stereo, 12.0volt 20Hz-20kHz <.018%THD 108w/ch 150w/ch 320w/ch - 2 ohm Stereo, 14.4volt 20Hz-20kHz <.02%THD 182w/ch 236w/ch 400w/ch - 1 ohm Stereo, 14.4volt 20Hz-20kHz <.05%THD * Signal to Noise Ratio >90dB * Frequency Response... - Page 11 We Want You Listening for a Lifetime Used wisely, your new sound equipment will provide a lifetime of fun and enjoyment. Since hearing damage from loud noise is often undetectable until it is too late, this manufacturer and the Electronic Industries Association’s Consumer Electronics Group recommend you avoid prolonged exposure to excessive noise.
Need help?
Do you have a question about the 300. S and is the answer not in the manual?
Questions and answers