D-Link AirPlus DWL-800AP+ Manual page 5

Connections
Ethernet Port – this RJ-45
Auto MDI/MDIX port provides
connection to a network
device using a
Cat 5 Ethernet
cable. (The Auto
MDI/MDIX port
accommodates either a
Straight-Through or a Cross-
Over cable and is auto-
sensing.)
Reset Button –
press this button to revert to
the factory default settings of
the DWL-800AP+
Power Receptor – connect
one end of the 5V DC Power
Adapter (included) to the power receptor on the DWL-800AP+ and connect
the other end of the Power Adapter to a power outlet.
Category 5 is the most reliable grade of twisted-pair cable. It Is available as either
Straight-Through cable or Cross-Over cable. Always check your installation
instructions to make sure that you have selected the correct type of Category 5
cable for your other networking devices. The DWL-800AP+ will accept either type
of cable and will automatically sense the cable that you are using.
Factory Default Settings for the DWL-800AP+*
Wireless Mode
SSID
Channel
Transmission rates
Encryption
Administrator password
IP Address mode
IP Address
IP Subnet
username
Power Receptor
Reset Button
Repeater
default
6
Auto
No
Blank (no password needed)
Static
192.168.0.30
255.255.255.0
admin (all lower case)
Ethernet