Notes On The Wireless Remote Commander; On Handling The Lcd Monitor - Sony FDR-AX100 How To Use Manual

recommended that you destroy the actual body of the memory card.
[193] How to Use

Notes on the Wireless Remote Commander

Remove the insulation sheet before using the Wireless Remote Commander.
Point the Wireless Remote Commander towards the remote sensor to operate this product.
When no commands have been sent from the Wireless Remote Commander within a certain
period, the light blue frame disappears. When you press any of
again, the frame appears at the position where it was last displayed.
You cannot select some buttons on the LCD monitor or on the viewfinder using
.
To change the battery of the Wireless Remote Commander
1. While pressing on the tab, inset your fingernail into the slit to pull out the battery case.
2. Place a new battery with the + side facing up.
3. Insert the battery case back into the Wireless Remote Commander until it clicks.
When the lithium battery becomes weak, the operating distance of the Wireless Remote
Commander may shorten, or the Wireless Remote Commander may not function properly. In
this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery
may present a risk of fire or explosion.
[194] How to Use

On handling the LCD monitor

Additional information
Additional information
Handling of this product
Maintenance
/ / / , or ENTER
/ / /