Serial Control Interface - Eiki LC-XL100 Owner's Manual

Appendix
This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port.
Operation
1 Connect a RS-232C serial cross cable to CONTROL PORT on
the projector and serial port on the PC. (See p.19)
2 Launch a communication software provided with PC and setup
the communication condition as follows:
Baud rate
Parity check
Stop bit
Flow control
Data bit

Note:
The default of the baud rate is set to 19200 bps. If an
error occurs in the communication, change the serial port
and the communication speed (baud rate).
 Type the command for controlling the projector and then enter
the "Enter" key.
Example
When you want to change the input to INPUT 2, Type 'C' '0' '6'
'Enter'.

Note:
Enter with ASCII 64-byte capital characters and one-byte
characters.
6
Serial Control Interface
: 9600 / 19200 bps
: none
: 1
: none
: 8