Final Installation; Troubleshooting - Jensen CD3010X Operation Manual

4. Final Installation

Replace any items
5
you removed
from the dashboard.
PW R
VO L
AU X
CD 30
10 X
SE L
M P3 /A
MU TE
UX IN
COM PU T
PAC
T
DIG
ITAL AUD
VO L IO
RP T
RP T A-
B
1 RD M
2 IN T
3 PG M
ME M/
4 CL R
5
6
Final Installation–ISO-DIN
Slide radio chassis into dash
2
opening and secure.

5. Troubleshooting

Problem
Does not operate (display
does not light)
No power to unit
No speakers operate
(display lights normally)
Not all speakers operate
Blows fuses
ER-2 appears on display
ER-3 appears on display
ER-4, ER-7, ER-8
appears on display
ER-5, ER-6 appears on display
CD skips too much
Technical Assistance
M – F 8:00 am to 6:00 pm EST @1.800.323.0221 • 365 / 24 / 7 @ www.jensenaudio.com
HI G H
PO W
ER 45
W x4
EL AP
SE
BA ND
AS /P
S
BA SS
SC AN
DI SP
PW R
VO L
AU X
CD 30
10 X
SE L
MP 3/A
MU TE
UX IN
PU T
COM PAC
T
DIGI TAL
VO L AUD IO
HI GH
PO W
RP T
ER 45
RP T A-B W x4
1 RD M
2 INT
3 PG M
ME M/
4 CL R
EL AP
5 SE
6
BA ND
AS /PS
BA SS
SC AN
DIS P
Reinstall dash panel.
3
Cause
No power to yellow wire
No power to red wire
Inline fuse blown
Inline fuse blown
Speaker harness not connected
Incorrect splices or connections
Speaker wires shorting to chassis
ground or to each other
Power wire shorting to ground
Speaker wires shorting to ground
Incorrect fuse/fuse too small
Disc loading malfunction
Disc eject malfunction
Disc reading malfunction
Track change malfunction
Receiver mount is not solid or
backstrap is not secure
Secure Radio to
4
bracket using nut.
(if possible)
2
Connect antenna lead.
Slide radio chassis
3
into half-sleeve.
Corrective Action
Check connection with test light.
Check vehicle fuse with test light.
Replace fuse.
Check/replace fuse.
Connect speaker harness.
Check speaker wires.
Check all splices and connections.
Check splices, insulate all bare wires.
Make sure wire is not pinched.
Make sure wire is not pinched.
Install fuse of correct rating.
Press RESET button. Insert disc and try again.
Press RESET button. Insert disc and try again.
Try a different disc. The disc may be
damaged or dirty.
Press RESET button. Insert disc and try again.
Check mounting and backstrap, tighten if
needed.
Connect wiring adapter
1
to existing wiring harness.
Mount factory brackets on
1
new radio using existing
screws from old radio.