Table of Contents
Advertisement
Using Metadata
Setting a User Memo Using Wi-Fi Remote
After completing the necessary preparations (A 49) you create a user memo profile and transfer it to the
camera from a Wi-Fi-enabled device using the Wi-Fi Remote application. Using the Wi-Fi Remote application
you have two additional advantages over user memos created with Canon XF Utility: you can change the user
98
memo of the last clip recorded, even if you did not specify a user memo in advance; and you can enter manually
the GPS information of your shooting location.
1 Press the [Metadata Input] tab on the Wi-Fi Remote screen.
2 Press [— Activate].
• Alternatively, on the camera, you can set [
3 Fill the necessary user memo and GPS information fields.
• You can press [Clear] to clear the information entered into each field.
4 Press one of the transfer options to transfer the metadata to the camera.
• [Metadata correctly transferred] will be displayed on the Wi-Fi Remote screen and the metadata will be
transferred and applied to the clips on the camera.
5 Press ^ to close the message.
Options
[Apply from Next]: Adds the metadata you set in Wi-Fi Remote to all clips recorded after the transfer.
[Overwrite Prev.]:
[Overwrite]:
NOTES
• The metadata sent to the camera from Wi-Fi Remote will be lost in the following cases.
- If the camera was turned off.
4K/2K/MXF Setup] > [Metadata] > [Setting] setting was changed.
- If the [
• Metadata sent to the camera from Wi-Fi Remote will not be added to relay clips recorded before the switch to
the current CF card.
Only available after recording a clip. Adds the metadata you set in Wi-Fi Remote to all clips recorded
after the transfer and also to the last clip recorded (overwriting any user memo that may have been
recorded previously with the clip).
Only available while recording a clip. Adds the metadata you set in Wi-Fi Remote to the clip that is
being recorded (overwriting any previous user memo). It will also add this metadata to all clips
recorded after the transfer.
4K/2K/MXF Setup] > [Metadata] > [Setting] to [Remote].
Advertisement
Table of Contents
