Table of Contents
Advertisement
Configuring Frame Recording Mode
1 Open the [Rec Frames] submenu.
4K/2K/MXF Setup] > [Frame Rec] > [Rec Frames]
[
2 Select the desired number of frames and then press SET.
Number of Frames Recorded
System priority
4K
2K
59.94i, 29.97P, 23.98P, 24.00P
MXF
59.94P, 50.00i, 50.00P, 25.00P
Activating Frame Recording Mode and Recording
1 Open the [Special Rec] submenu.
4K/2K/MXF Setup] > [Special Rec]
[
2 Select [Frame Rec] and then press SET.
• [FRM STBY`] (during 4K and 2K modes) or [FRM STBY] (during
MXF mode) appears at the top of the screen (with [FRM] flashing).
3 Press the START/STOP button to begin recording.
• The set number of frames are recorded automatically.
• The tally lamp illuminates.
• [FRM] changes to [Ü FRM].
• Repeat until you finish recording.
4 Open the [Special Rec] submenu.
4K/2K/MXF Setup] > [Special Rec]
[
5 Select [Off] and then press SET.
• Frame recording mode ends and all of the recorded frames are joined together into one clip.
• [STBY`] (during 4K and 2K modes) or [STBY] (during MXF mode) appears at the top of the screen.
• The tally lamp goes out.
NOTES
• You can use only one special recording mode at a time.
• While recording, you cannot change the number of frames.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• Frame recording mode will be deactivated if the special recording mode is changed or turned off. It will be
deactivated also if you change the video configuration.
• During this special recording mode, the running mode of the time code (A 84) can be set to [Rec Run] or
[Regen.]*. The time code advances by the number of frames recorded. If the running mode of the time code
(A 84) is set to [Free Run] or the time code is input from an external source, the running mode will switch to
[Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will
return to its previous setting.
• During special recording mode, the time code signal will not be output from the MON. terminals, TIME CODE terminal
or HD/SD SDI terminal. During 4K and 2K modes, the time code signal will be output from the 3G-SDI terminals.
* During MXF mode only.
Frame rate
Frames recorded
Any
[
1, 3, 6, 9
2, 6, 12
[
Special Recording Modes
4K/2K/MXF Setup]
Frame Rec]
[
[Rec Frames]
[1]
4K/2K/MXF Setup]
Special Rec]
[
[Off]
107
Advertisement
Table of Contents
