Hardware Installation - EnGenius EW310AP User Manual

Hardware Installation

1. Ensure that the computer in use has an Ethernet Controller port (RJ-45 Ethernet Port). For more information, verify with your
computer's user manual.
2. Connect one end of the Category 5e Ethernet cable into the RJ-45 port of the EWS310AP/EWS320AP and the other end to
the RJ-45 port of the computer. Ensure that the cable is securely connected to both the EWS310AP/EWS320AP and the
computer.
3. Connect the Power Adapter DC connector to the DC-IN port of the EWS310AP/EWS320AP and the Power Adapter to an
available electrical outlet. Once both connections are secure, verify the following:
a) Ensure that the POWER light is on (it will be orange).
b) Ensure that the 2.4 GHz/5 GHz WLAN light is on (it will be blue for 2.4G, and green for 5G).
c) Ensure that the LAN (Computer/EWS310AP/EWS320AP Connection) light is on (it will be blue).
d) Once all three lights are on, proceed to set up the Access Point using the computer.
This diagram depicts the hardware configuration.