Programming Rf Control Options; The Rf Setup Window; Adjusting Signal And Ir Output Options - Universal Remote Control MX950 Programming Manual

36

Programming RF Control Options

U

The RF Setup Window

S
The RF Setup window opens after selecting RFControl from the Program Menu or
clicking on the shortcut button.
I
N
G
M

Adjusting Signal and IR Output Options

X
The RF Setup window enables you to adjust the properties of RF Control by clicking on the intersection of a row and a
column and then selecting from the pull down list box the property you want. All of your devices are displayed. You can
9
set each device individually to be controlled by clicking on the cell you want to change. After clicking, a list box of
options will appear.
5
0
S controls how the MX-950 will send
IGNAL
commands:
IR and RF - Both RF signals and IR com-
E
mands are sent from the MX950.
The RF signals will also be
D
issued as IR commands by the
I MRF-300.
IR - Only IR commands are sent from
T
the MX950, as a result the MRF-
300 does not send any com-
O
mands.
RF - Only RF signals are sent from the
R
MX950, as a result only IR com-
mands from the MRF-300 are
received by the device.
T
O
R enables you to select which MRF-300
ECEIVER
P
receiver will receive the commands for this
device. Thus, you can send commands to a
R
device in another location via a second MRF-
300 placed in that location (up to 16 in one
O
house).
G
Note: In a system with only one MRF-300
R
receiver, this does not need to be adjusted.
A
M
RF Control