Cisco UCS B200 M3 Installation And Service Note page 33

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
If you are switching from one type of adapter card to another, before you physically perform the switch
make sure that you have downloaded the latest device drivers and loaded them into the server's operating
system. For more information, refer to the firmware management chapter of one of the UCS Manager
software configuration guides.
To install an adapter card on the blade server, follow these steps:
Position the adapter board connector above the motherboard connector and align the two adapter captive
Step 1
screws to the standoff posts on the motherboard.
Firmly press the adapter connector into the motherboard connector.
Step 2
Tighten the two captive screws.
Step 3
Removing an adapter card is the reverse of installing it. You may find it helpful when removing the
Tip
connector from the motherboard to gently rock the board along the length of the connector until it
loosens.
Figure 21
OL-26624-01
Installing an Adapter Card
3
Cisco UCS B200 M3 Blade Server Installation and Service Note
1
1
Memory and Performance
2
33