Horizon Fitness HORIZON SERIES T90 User Manual page 5

P R E- ASSE MBLY
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
AS SE MB LY ST EP 1
HARDWARE BAG 1 CONTENTS :
FRAME EXTENSION TUBE
BOLTS (A)
CONSOLE MAST SUPPORT TUBE

T90_Rev.1.5.indd 8-9
A Open HARDWARE BAG 1.
B Slide the left frame extension
BOLT (A)
15 mm
tube onto the console mast
Qty: 4
support tube. Bolt in place
using 2 BOLTS (A) on the side.
C Repeat on the other side.
ASSEMBLY STEP 2
HARDWARE BAG 2 CONTENTS :
BOLT (B) SPRING WASHER (C)
15 mm 15 mm
Qty: 8 Qty: 8
CONSOLE CABLE
(THREAD THROUGH
INSIDE HOLE IN MAST)
RIGHT CONSOLE MAST
CONSOLE MAST
SUPPORT TUBE
ARC WASHER (E)
SPRING WASHER (C)
BOLT (B)
FLAT WASHER (D)
SPRING WASHER (C)
BOLT (B)
FLAT WASHER (D) ARC WASHER (E)
15 mm 17 mm
Qty: 4 Qty: 4
A Open HARDWARE BAG 2.
B Slide the left CONSOLE MAST
down onto the CONSOLE MAST
SUPPORT TUBE. Bolt in place
using 2 BOLTS (B), 2 SPRING
WASHERS (C), and 2 FLAT
WASHERS (D) on the side. Then,
bolt in place using 2 BOLTS (B),
2 SPRING WASHERS (C), and 2
ARC WASHERS (E) on the front.
C Repeat on the other side.
Note: On RIGHT CONSOLE MAST,
the CONSOLE WIRE must be
threaded through the mast.
NOTE: Do not completely tighten any
screws or bolts until step 5 is complete!
NOTE: Be careful not to pinch any wires
while assembling the masts.
9
9/10/08 4:21:01 PM