LG GCE-8520B Owner's Manual page 11

DirectCD TM v2.5b(s)
PC Connection
To Install as a
Master Drive
Installation
The CD-R/RW drive connects to the motherboard of the host computer
using an IDE interface cable. You may connect the CD-R/RW Drive as a
Slave or Master device, depending on your computer.
To install the drive as a Master, the jumper can be left as supplied from
the factory.
Master drive
(Booting hard disk)
Primary
connector
Master drive
(Booting hard disk)
Primary
connector
NOTE : A hard disk is normally installed as the Primary Master on the
EIDE (ATAPI) interface. Other EIDE peripheral devices such as hard
drives and CD-ROMs are then set differently.
8
- OR -
Slave drive
(Other IDE drive)
Secondary
connector
Master drive
(CD-R/RW drive)
(Jumper left as
MAster)
Motherboard
Secondary
connector
Master drive
(CD-R/RW drive)
(Jumper left as
MAster)