Replacing The Optical Drive - Lenovo ThinkCentre Hardware Maintenance Manual

Figure 25. Installing the secondary hard disk drive
12. Connect the signal cable and the power cable to the new hard disk drive.
13. Go to "Completing the parts replacement" on page 94.

Replacing the optical drive

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy
of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to install or replace the optical drive.
To install or replace an optical drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 64.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 68.
4. Depending on whether you are installing or replacing an optical drive, do one of the following:
• If you are installing a secondary optical drive, remove the plastic panel in the front bezel for the
drive bay you want to use. If there is a metal static shield installed in the drive bay, remove the
metal static shield.
• If you are replacing an optical drive, disconnect the signal cable and the power cable from the rear
of the optical drive, press the blue release button, and then slide the optical drive out of the front
of the computer.
.
Chapter 8 Replacing FRUs (Machine Types: 3029, 3054, 3139, 3219, 3246, 3282, 3349, 3421, 3544, 3652, 3769, 3934,
4992, 5206, 5267, 5325, 5384, 5450, 5474, 5498, 5554, 5852, 6232, and 6590.)
85