Lenovo ThinkCentre Hardware Maintenance Manual page 56
Machine types: 3026, 3029, 3039, 3054, 3137, 3139, 3149, 3219, 3245, 3246, 3245, 3282, 3319, 3349, 3394, 3421, 3491, 3544, 3627, 3652, 3699, 3769, 3878, 3934, 4972, 4992, 5132, 5206, 5261, 5267, 5297, 5325, 5384, 5391, 5450, 5472, 5474, 5485, 5498, 5536,
Hide thumbs
Also See for ThinkCentre:
- Hardware maintenance manual (546 pages) ,
- Safety and warranty manual (265 pages) ,
- User manual (32 pages)
Table of Contents
Advertisement
Diagnostic Error Code
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
015-035-XXX USB port Reset condition detected
015-036-XXX USB port Register error
015-040-XXX USB port IRQ failure
015-195-XXX USB port Test aborted by user
015-196-XXX USB port test halt, error threshold exceeded
015-197-XXX USB port test warning
015-198-XXX USB port test aborted
015-199-XXX USB port test failed, cause unknown
018-000-XXX PCI Card Test Passed
018-0XX-XXX PCI Card Failure
018-195-XXX PCI Card Test aborted by user
018-196-XXX PCI Card test halt, error threshold exceeded
48
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 366
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 366.
3. Run memory test
4. System board
1. Remove USB device(s) and re-test.
2. System board
System board
1. Run the Setup Utility program and check for conflicts.
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 366.
3. System board
Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See "" on page .
2. Re-run the test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
1. If a component is called out, make sure it is
connected and/or enabled. See "" on page .
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 366.
3. Go to "Undetermined problems" on page 60.
1. Go to "Undetermined problems" on page 60.
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 366.
3. Replace component under function test.
No action
1. Riser card, if installed
2. System board
1. PCI card
2. Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
Advertisement
Table of Contents
