Table of Contents
Advertisement
2.2 Dismounting the Tractor
Before dismounting the tractor, idle the tractor engine down, disengage the head and retract the boom arm to
the transport position. Park the tractor on a level surface, set the transmission in park or neutral and apply
the parking brake. Shut down the tractor engine, remove the key, and wait for all motion to come to a
complete stop before exiting the operator's seat. NEVER leave the seat until the tractor, its engine, and
mower head movement have come to a complete stop.
Use hand rails and extra steps when exiting the tractor. Be careful of your step and use extra caution when
mud, ice, snow, and other matter has accumulated on the steps and handrails. Never rush or jump off the
tractor. OPS-B- 0002
BEFORE leaving the tractor seat, always engage the brake and/or set
the tractor transmission in parking gear, disengage the PTO, stop the
engine, remove the key, and wait for all moving parts to stop. Place the
tractor shift lever into a low range or parking gear to prevent the tractor
from rolling. Never dismount a Tractor that is moving or while the engine
is running. Operate the Tractor controls from the tractor seat only.
3.STARTING THE TRACTOR
The operator must have a complete understanding of the placement, function, and operational use of all
tractor controls before starting the tractor. Review the tractor operator's manual and consult an authorized
dealer for tractor operation instructions if needed.
Essential Tractor Controls:
•
Locate the ignition key/switch
•
Locate the engine shut off control
•
Locate the hydraulic control levers
•
Locate the light control lever
•
Locate the brake pedals and clutch
•
Locate the PTO control
•
Locate the 3 point hitch control lever
•
Locate the boom operating controls (joystick or valve bank)
Before starting the tractor ensure the following:
•
Conduct all pre-start operation inspection and service according to the tractor operator's manual.
•
Make sure all guards, shields, and other safety devices are securely in place.
•
The parking brake is on.
•
The tractor transmission levers are in park or neutral.
•
The boom operating controls are in the neutral and off position.
•
The PTO control lever is disengaged.
•
The hydraulic remote control levers are in the neutral position.
Refer to the tractor owner's manual for tractor starting procedures. Only start the tractor while seated and
belted in the tractor operator's seat. Never bypass the ignition switch by short circuiting the starter solenoid.
After the tractor engine is running, avoid accidental contact with the tractor transmission to prevent sudden
and unexpected tractor movement.
AXTREME 03/09
©2009 Alamo Group Inc.
OPERATION
OPS-B- 0003
Operation Section 3-7
(SG-9)
Advertisement
Table of Contents
