Table of Contents
Advertisement
FILTER
It is recommended that you replace the filter
approximately every 6 months,
when the water filter indicator
(
) turns on, or when the
ice and water dispenser
noticeably decreases output.
1. Remove the old filter.
• Press the push button to
open the filter cover.
NOTE: Replacing the filter
causes a small amount of
water (around 1 oz. or
25 cc) to drain. Place a cup
under the filter hole to catch
any waste.
• Pull the filter downward
and pull out.
2. Replace with a new filter.
• Take the new filter out of it's packaging and
remove the protective cover from the o-rings.
With filter "tabs" in the horizontal position, push
the new filter into the manifold hole until it stops.
FILTER
• Firmly lock in the filter.
The cover will click back into
place.
3. After replacing the filter, flush 2.5 gallons through
filter before use (flush for approximately
5 minutes) and check the filter for leaks.
To reset the water filter status display and
indicator light, press and hold the Ultra Ice (Fliter
Reset) button for at least 3 seconds.
4. Filter Bypass Plug
Keep the filter bypass plug.
You MUST use the filter bypass
plug when a replacement filter
cartridge is not available.
CAUTION: DO NOT operate
w w
refrigerator without filter or
filter plug installed.
NOTE: To purchase replacement water filter, visit
your Sears store or 1-800-4MY- HOME. Also
visit us on the web at
www.sears.com/partsdirect.
28
Filter Bypass
Plug
Hide quick links:
Advertisement
Table of Contents
