Power Saving Function - Nikon COOLPIX L120 Quick Start Manual

2.3
Close the battery-chamber/memory card slot cover.
Slide the cover while securely holding down the area marked
@.
Step
3
Turn On the Camera
Remove the lens cap and press the power switch.
I
• The power-on lamp (green) will light, and then the monitor will turn on (the
power-on lamp turns off when the monitor turns on).
• If Remove the lens cap, and turn the camera off and then on again. is
displayed, make sure that the lens cap has been removed, and then turn the
camera on again.
PI
Power Saving Function (Auto Off)
If no operations are performed for a while, the monitor will turn off, the camera will enter
standby mode, and the power-on lamp will blink. If no operations are performed for another
three minutes, the camera will turn off automatically.
When the power-on lamp is blinking, pressing any of the following buttons will turn the
monitor back on.
~
Power switch, shutter-release button,
0
button,
~
button, or.
(~
movie-record) button
• First Steps