Lenovo ThinkCentre Hardware Maintenance Manual page 58

Diagnostic Error Code
025-027-XXX IDE interface Configuration/Setup error
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface
failure
025-195-XXX IDE interface Test aborted by user
025-196-XXX IDE interface test halt, error threshold
exceeded
025-197-XXX IDE interface test warning
025-198-XXX IDE interface test aborted
025-199-XXX IDE interface test failed, cause unknown
030-000-XXX SCSI interface Test Passed
030-00X-XXX 030-01X-XXX SCSI interface failure
030-027-XXX SCSI interface Configuration/Setup error
52
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. IDE signal cable
2. Flash the system. See "Flash update procedures"
on page 175
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Check power supply
3. Reseat IDE signal cable
4. IDE device
5. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 37
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 37
2. Flash the system and re-test. See "Flash update
procedures" on page 175
3. Go to "Undetermined problems" on page 63
1. Go to "Undetermined problems" on page 63
2. Flash the system and re-test. See "Flash update
procedures" on page 175
3. Replace component under function test
No action
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Flash the system. See "Flash update procedures"
on page 175
3. SCSI device
4. SCSI adapter card, if installed
5. System board