Replacing The Rear I/O Shielding; Removing The Rear I/O Shielding - Lenovo ThinkCentre Hardware Maintenance Manual

4. Install the rear I/O shielding. See "Installing the rear I/O shielding" on page 74.
5. Go to "Completing the FRU installation" on page 108.

Replacing the rear I/O shielding

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy
of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the rear I/O shielding.

Removing the rear I/O shielding

To remove the rear I/O shielding, do the following:
1. Turn off the computer.
2. Disconnect all cables, power cords, and external options from your computer. See "Rear connectors"
on page 65.
3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
4. Remove the computer cover. See "Removing the computer cover" on page 70.
5. Locate the rear I/O assembly on the system board. See "System board connectors" on page 68.
6. Remove the two screws that secure the rear I/O shielding to the rear I/O assembly. Carefully remove
the rear I/O shielding from the rear I/O assembly.
.
Chapter 8 Replacing FRUs
73