Table of Contents
Advertisement
2 - 7
Hard surface floor cleaning
The power nozzle can be used for
cleaning hard surface floors such as
wood, linoleum, vinyl, asphalt and rub-
ber tile, sealed cork, concrete and ter-
razzo, as well as carpet.
To set the power nozzle for hard surface
floor cleaning, push the floor surface
selector button toward "BARE" (E). This
setting provides suction and no agitator
action. If you prefer, you may use the
hard floor tool to clean bare floors.
You will find it particularly convenient
when cleaning lightweight area rugs to
set the floor surface selector button on
"BARE" and continue cleaning the sur-
rounding floor surfaces.
Note: The headlight will be ON in both
the "RUG" and "BARE" floor surface
.
modes
Cleaning tools
The cleaning tools are conveniently
stored in the cleaner underneath the tool
lid. Pull up on edge of lid in recessed
area to open.
The lid is also designed with a "break-
away" feature which allows it to snap off
if it is pushed open too far. To re-attach,
align small knobs on hinge area of lid
with slots at rear of cleaner; press lid
back into place.
The cleaning tools have many uses.
Select the tool best suited for the clean-
ing task from the following descriptions.
2 - 1 0
H
J
I
K
6
2 - 8
E
Edge cleaning
Special edge groomers are provided on
both sides of the nozzle to remove dirt in
carpet near baseboards and furn i t u re .
Guide side of nozzle parallel to edge of
carpet or furn i t u re as shown.
Select the proper tool
H. Crevice tool may be used in tight
spaces, corners, and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
I. Furniture nozzle may be used for
upholstered furniture, draperies, tapes-
tries, mattresses and clothing.
J. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters and registers.
K. Hard floor tool may be used for
walls and very irregular hard surface
floors such as brick and slate.
L. Powered hand tool may be used for
upholstered furniture, carpeted stairs,
L
and hard to reach places.
2 - 9
Variable speed control
The variable speed control (F) is located
on the hand grip.
Slide the control back to reduce energ y
consumption and to clean lightly soiled
a reas or delicate fabrics. Slide control for-
w a rd for maximum cleaning power in
heavily soiled areas. If the power nozzle is
d i fficult to push, slide the control toward
back to reduce the pow e r. This will help
p r event damage to the belt.
2 - 1 1
How to connect
To use the cleaner with tools, disconnect
the power nozzle from the hand grip.
Tools may be attached directly to the
hand grip. With the latch in the unlock
position, insert tool (or wand if extra
length is needed), then push latch to the
lock
position to secure.
To remove the tool (or wand), push the
latch to the unlock
position.
To connect tools to metal wands, insert
end of tool into wand and snap into
position. To disconnect, press down on
the center of spring latch and remove
tool.
F
Advertisement
Table of Contents
