Table of Contents
Advertisement
7. Remove the power cord connector from the rear I/O assembly.
Figure 23. Removing the power cord connector
8. Disconnect the serial-connector cable and the PS/2 keyboard/mouse cable (if necessary) from the
system board. Then, remove the rear I/O assembly from the chassis.
9. To install the new rear I/O assembly, connect the PS/2 keyboard/mouse cable (if necessary) and the
serial-connector cable of the new rear I/O assembly to the system board. See "Locating parts on the
system board" on page 71.
10. Note the orientation of the power cord connector and install it onto the new rear I/O assembly. Ensure
that the two screw holes in the power cord connector align with the corresponding holes in the new
rear I/O assembly.
.
Chapter 8
Replacing FRUs
89
Advertisement
Table of Contents
Troubleshooting
