Table of Contents
Advertisement
6. To install the hard-disk-drive EMI shield, align the hole in the EMI shield with the standoff in the chassis
as shown. Then, push the EMI shield straight down until it is secured by the standoff firmly and the three
tabs
1
on the EMI shield also are secured by the corresponding holes in the chassis.
Figure 12. Installing the hard-disk-drive EMI shield
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 119.
Replacing the 3.5-inch hard disk drive or hybrid drive
This section provides instructions on how to replace the 3.5-inch hard disk drive.
Attention: Before you replace any FRU, be sure to read and understand Chapter 1 "Safety information" on
page 1. These precautions and guidelines will help you work safely.
CAUTION:
Turn off the computer and wait three to five minutes to let the computer cool before removing the
computer cover.
.
Chapter 8
Replacing FRUs
79
Advertisement
Table of Contents
Troubleshooting
