Advertisement
2
INSTALL POP-UP DRAIN
Push Tail piece (11) down into Trap (C) (threaded end up).
Thread Locknut (5), Washer (4) and Gasket (3) (Bevel side
up) onto Drain Body (10).
Apply a bead of Putty (D) to underside of Flange (2).
Feed Drain Body (10) up through Sink (A) and thread the
Flange (2) fully onto Drain Body (10).
Tighten Locknut (5) firmly using channel locks, keeping the
pivot rod hole pointed towards the back of the sink.
Assemble Pivot Rod (9) as shown in Figure-2B. Notice the
position of the Concave Washer (G).
Insert Pivot Rod (9) into Drain Body (10) and tighten Pivot
Nut (F).
Push Tailpiece Insert (12) into Tailpiece (11) and push
Tailpiece up and thread tightly into Drain Body (10).
Position Extension Rod (7) onto Pop-Up Rod (E) and tighten
Thumbscrew (6).
Remove one end of Clip (8) from Pivot Rod (9) by squeezing
ends together while sliding.
Insert Pivot Rod (9) into second or third hole in Extension
Rod (7) and reassemble Clip (8).
Drop Stopper (1) into Drain Body (10).
Adjust stopper height by repositioning Extension Rod (7) and
tightening Thumbscrew (6).
3
TEST FAUCET
Remove Aerator.
Turn on water supplies and check for leaks.
Operate Handle up and down, and left and right and check
for proper operation.
Flush lines and reinstall Aerator.
4
ADJUST HOT LIMIT STOP
Turn on valve and allow water supply temperatures to
stabilize. Move HANDLE to full HOT setting. Check
water temperature.
To decrease hot limit temperature setting:
Pull out Plug Button (1), loosen Handle Set Screw (2)
and remove Handle (3) from Cartridge Stem (5). Remove
Cartridge Cover (4).
Lift Setting Insert (6), rotate counterclockwise one notch and replace.
Check water temperature and repeat if necessary. Unit is factory set
at "0" (full HOT water). As the setting number increases, the more cold
water is supplied in the full HOT handle position.
Replace Cartridge Cover (4). Align Handle (3) and tighten Set Screw (2).
Replace Plug Button (1).
5
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
1
2
A
3
4
5
10
12
11
3
1
4
2
5
FIGURE-2B:
0-RING
G
F
D
E
6
7
F
8
C
1-1/4"
9
TOP
CARTRIDGE
HOTTEST
Blend control
setting 0 - setting
insert covers blend
TOP
control setting
number 1 - 4
COOLEST
Blend control
setting 4
M 9 6 8 7 1 2 R E V . 1 . 2
6
Advertisement
