ENFIELD
BATH/SHOWER
TRIM KITS
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
ATTENTION:
If TRIM T373.742 or diverter tub spout is used
make sure TWIN ELL (B) P/N 8888.120 is
connected to valve body as indicated in roughing-
in sketch.
TWIN ELL
TWIN ELL P/N 8888.120 can be ordered as
shown in the American Standard List Price Book
ROUGHING-IN DIMENSIONS
Installation for Bath/Shower,
Shower only, or Valve only Trim.
Dimensions are for reference.
FINISHED WALL
1/2" NPT
1" MIN.
7-7/8" REF.
4"
9-1/2"
1" MIN.
4"
5-3/4" REF.
1/2" NPT
BOTTOM OF TUB
Required Tools
Phillips Screwdriver
Adjustable Wrench
Installation
Instructions
1
5-1/8" REF.
OPTIONAL TO FINISHED
FLOOR USUALLY
BETWEEN 74'' AND 80''
FOR HEAD CLEARANCE
18" OPTIONAL
TOP OF
TUB RIM
Flat Blade Screwdriver
Channel Locks
T373.742
T373.741
T373.740
CAUTION: Protect finish on SHOWER ARM,
INSTALL
SHOWER HEAD and TUB SPOUT when installing.
TRIM
When finished tiling the wall, remove PLASTER GUARD (A) and
turn off water supply.
Attach STEM ADAPTER (1) to TEMPERATURE CONTROL (2) valve
stem with SELF TAPPING SCREW (3). Attach HANDLE SCREW (4)
to VOLUME CONTROL ADAPTER (5).
Push CAPS (6) onto TEMPERATURE CONTROL (2) and VOLUME
CONTROL ADAPTER (5).
Mount ESCUTCHEON (7) to valve body with SCREWS (8).
Push DIAL PLATE (9) over CAPS (6) and into the four alignment holes in
ESCUTCHEON (7) and snap into place.
Remove PIPE CAP (10) and PIPE CAP (11) from shower pipe and tub filler pipe.
Install SHOWER ARM (17) with SHOWER ARM ESCUTCHEON (18),
SHOWER HEAD (12) and TUB FILLER SPOUT (13) by threading onto
pipe nipples. Use teflon tape or pipe sealant on pipe threads.
18
10
5
4
TWIN ELL (B)
2
3
1
11
Certified to comply with ANSI A112.18.1
M 9 6 8 2 9 4 R E V 1 . 1
17
12
PLASTER GUARD (A)
6
7
(4) ALIGNMENT
8
13
HOLES FOR
DIAL PLATE
9