Function Of Dispenser And Water Dispenser Built-In; Demonstration Mode Sequence - Kenmore 795.58812.900 Service Manual

2-16. Function of dispenser and water dispenser built-in

1. The dispenser allows ice and water to be served without opening the freezer door.
2. Press the dispenser switch (the rubber button) after selecting crushed ice, cubed ice or water. The dispenser door will
open automatically. It will close automatically 5 seconds after dispensing is completed, and you will hear the CLICK.
3. The dispenser will not operate when the freezer door is open.
4. The ice dispenser will automatically stop after 3 minutes even without an OFF signal. The ice door will close automatically
5 seconds after that, and you will hear the CLICK.
5. Dispenser Lamp ON/OFF function.
The dispenser lamp is operated in conjunction with the dispenser switch. It comes on when ice or water is dispensed, and
turn off when dispensing is completed.
6. Selection function of water/crushed/cube ice
1) This allows the selection of water/cubed/crushed ice. Press the button to cycle trough WATER
2) At initial power-on, the dispenser defaults to CUBED ICE.
3) When CUBE ICE is selected, the geared motor rotates, and the Solenoid Cube is activated, so CUBE ICE is dispensed.
4) When CHRUSHED ICE is selected, the geared motor rotates, and the Solenoid Cube is deactivated, so CRUSHED ICE
is dispensed.
7. Water dispenser function
1) Select WATER to dispenser water.
2) The water line is a direct connection to the household water supply. If water is selected at the dispenser, a solenoid
opens and allows water to flow. A similar solenoid is operated in conjunction with the ice maker to fill it at the
appropriate time in its cycle.

2-17. Demonstration MODE Sequence

1. Any Door must be opened to enter in this mode.
2. When the ULTRA ICE button and REF. TEMP button are pushed at the same time and hold for 5 seconds or longer, it
converts to Demonstration Mode Sequence. You will hear a sound indicating Demo Mode Sequence is activated.
3. In Demo Mode Sequence, cooling system is disabled, only lamps and display works normally.
4. To disable Demo Mode Sequence, push ULTRA ICE button and REF. TEMP button at the same time and hold for 5 seconds
or longer. You will hear a sound indicating Demo Mode Sequence is deactivated.
- 18 -
CRUSHED CUBED.