Panasonic G600 Service Manual page 66
Personal cellular telephone, handheld portable, battery packs, handsfree car mount kit, easy fit car kit, hands free car kit, simple car kit, dc adaptor, dual charger, ac adaptor, data interface cable, sms interface cable
Hide thumbs
Also See for G600:
- Technical manual (45 pages) ,
- Service manual (113 pages) ,
- Service manual (108 pages)
Table of Contents
Advertisement
TEST AND MEASUREMENT
2. Ensure that the following settings are made:
a)
Interface box IFB002
Power:
IGN:
HH/HF:
MODE:
b)
Power supply
+12V DC:
c)
PC
Channel box software loaded and the screen indicating as shown (figure 8):
Figure 8: PC Screen (SCRN9)
3. On the PC press ENTER.
4. Switch on the 12V supply.
5. At the PC press F10.
6. At the Interface box switch the POWER to ON.
Entering Call Mode from Test Mode
The screen of the PC will resemble the one shown in figure 8:
Figure 9: PC Screen (SCRN11)
1. At the PC change the SOFT SIM field to read <ENB>. Press ENTER.
2. At the PC change the TEST field to read <TERM>. Press ENTER.
The UUT will power down and up again. If the UUT is connected to a GSM test set, after a delay of
approximately 5 seconds the UUT will register service.
3. To return to test mode, set SOFT SIM field to <DIS> and set TEST field to <Test>. Press ENTER.
Issue 1
Revision 0
DOWN position
DOWN position
DOWN HH position
UP position
OFF
Section 7
7 - 6
600-0720
500-0721
MCUK980101C8
Service Manual
Advertisement
Table of Contents
