Work Piece And Work Area Set Up; General Operating Instructions - Chicago Electric 68221 User Manual

Work Piece and Work Area Set Up

1. Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Chain Stop (39)
Lock
Knob
(42)
Lock
Nut
(43)
Page 8
Transmission Shafts (51)
Figure 3
For technical questions, please call 1-800-444-3353.
5. Clean the chain saw before sharpening. Wash it
with nonflammable solvent. Do not use gasoline.
6. Dry chain before sharpening.

General Operating Instructions

1. Lift the Chain Stop up and place the chain to
be sharpened inside the slot along the center
of the Vise Base. NOTE: Make sure the
sharp edge is facing towards the right.
2. Turn the Transmission Shafts to secure the chain saw
link in place along the Vise Base. See Figure 3, below.
3. Lower the Chain Stop so that is positioned on the
chain tooth you want to start sharpening with.
SKU 68221