Fuel, Lubricants & Coolants; Fuel; Lubricants - TATA Motors Sumo Victa EX Owner's Manual & Service Book

CARE AND CLEANING OF VEHICLE
Remove dirt and mud from body exterior with running water.
Use a soft sponge, brush with water. Do not use hard
material which can scratch the paint.
Wash the exterior with water, lightly rubbing with sponge or
soft cloth. The sponge or cloth should frequently soaked in
water.
Caution
When using commercial wash products precautions
specified by the manufacturer should be observed. Do not
use strong household detergents or soaps.
Once dirt has been completely removed, wash off with
running hose water.
After rinsing, wipe the body lightly with wet chamois or cloth
and allow the body to dry it in the shade.
Warning
After washing, check that the brakes are dry. If brakes are not dry,
dry them by gently, repeatedly applying while driving at low
speeds.
Washing the vehicle exterior
After washing the vehicle, waxing and polishing are
recommended to protect and beautify the paint.
Use only good quality waxes and polishes.
When using waxes and polishes, the precautions specified
by the manufacturers should be observed.
Ofrecido por www.electromanuales.com
V E H I C L E M A I N T E N A N C E
Chrome plated parts should also be waxed.
Protection against corrosion :
The following cause corrosion :
Moisture trapped in body cavities.
Dirt and salts collected in hollows on the underside of the
vehicle.
Removal of paint and protective coatings from the exterior
and underside of the vehicle.
Corrosion preventive measures have been incorporated in
your vehicle. You can avoid corrosion of your vehicle by
performing some simple periodic maintenance :
Repair chips and scratches in the paint as soon as you
discover them.
Inspect and clean the drain holes in the bottom of the
doors and body.
Check the floor coverings for dampness. Carpets and floor
mats remain damp for a long time, especially in winter. This
can eventually cause the floor panels to corrode.
Use a high pressure spray to clean the underside of your
vehicle. This is especially important in areas near chemical
and other industries.
Have corrosion preventive coatings done on the underside
of your vehicle using Tata Motors co-branded anti
corrosive treatment.
78
F U E L , L U B R I C A N T S & C O O L A N T S

Fuel

High speed diesel conforming to IS 1460 (2000) or DIN 51601
or equivalent is recommended to be used as fuel.
At very low temperature fluidity of diesel may become
insufficient due to paraffin separation. It is therefore,
necessary to mix supplementary fuel with summer or winter
grade diesel. The supplementary fuel to be used is kerosene
or aviation turbine fuel.
Ratios for mixing of supplementary fuel and diesel are shown
in table :
Ambient Percentage
temperature upto Summer Supplementary
0
C grade diesel fuel
upto 0 100 0
0 to -10 70 30
-10 to -15 50 50
FUEL, LUBRICANTS
Ambient Percentage
temperature upto Winter Supplementary
0
C grade diesel fuel
upto -15 100 0
-15 to -20 70 30
-20 and below 50 50
Care should be taken that diesel and supplementary fuel are
thoroughly mixed before filling.

Lubricants

Recommended lubricants conform to the following
specifications :
1. SAE 15W40 to API CF4+ - Engine oil
2. ATF Type A - Gearbox oils
3. APIGL 5 - Rear axle and
mechanical
steering gear box oils
Please use only recommended brands for good
performance.
79