Delete A Tour; Programming Sector Ids - Honeywell HEGS5000 User Manual

5.2.11 Delete a Tour

1. Press the Dome Menu (
2. Press + or – until Tour Menu is displayed.
3. Press Enter (
4. Press + or – until Delete is displayed.
5. Press Enter (
6. Enter the desired tour # (1-3) using the numeric keys.
7. Press Enter (

5.2.12 Programming Sector IDs

Sector IDs are used for labeling specific areas that the PTZ camera views. Whenever a
PTZ camera is under manual control and it is viewing a programmed sector, the name
given that sector is added to the video signal.
Note: The camera ID display must be enabled. When an operator is viewing the monitor
or a video recorder is recording a specific dome, this labeling provides a quick
reference for the area being displayed. Up to 16 Sector IDs can be programmed
for each Scan Unit.
1. Press the Dome Menu (
2. Press + or - until Sector/Priv Menu is displayed.
3. Press Enter (
4. Press + or – until Program is displayed.
5. Press Enter (
6. Enter the desired sector number (0-15) to program.
7. Press Enter (
Rev. 1.01
1. ___
) key.
3. ___
).
).
).
1. ___
) key.
3. ___
).
).
).
34
900.0800
19-Jun-06